BALL STRAP ELECTRIC CONTROL HANDLE W/ BALL STRAP

BALL & STRAP ELECTRIC CONTROL HANDLE W/ BALL & STRAP

This product is compatible with the following OEM manufacturers

IDS Blast is an authorized distributor of Pirate Brand®, RPB Safety®, Bullard®, Blast-It-All®, Trinco™ & Graco®.
We are not an authorized distributor of the other manufacturers listed above.

MUST USE SEALED CONNECTOR PB-31131 WHEN USING STEEL ABRASIVES

THIS PRODUCT FEATURES A BALL AND STRAP DESIGN SO THAT IF THE OPERATOR DROPS THE BLAST HOSE, THE BALL THAT IS STRAPPED TO THEIR WRIST DISENGAGES THE CONTROL HANDLE

WARNING!  WHEN USING THIS CONTROL HANDLE, THE STRAP MUST BE SECURED AROUND THE OPERATORS WRIST.  IT IS UNSAFE TO USE THIS CONTROL HANDLE WITHOUT THE BALL & STRAP

PROPER REMOTE CONTROL ATTACHMENT INSTRUCTIONS
ATTACH THE REMOTE CONTROL HANDLE TO THE BLAST HOSE NEAR THE NOZZLE WITH HOSE CLAMPS OR HEAVY WIRE TIES.  FORM A LOOP OF TWINLINE/CONTROL CORD THAT COMES 6" AWAY FROM THE BLAST HOSE, RUNS 6" PARALLEL TO THE BLAST HOSE, AND COMES 6" BACK TO THE BLAST HOSE.  USING DUCT TAPE, ATTACH THE TWINLINE/CONTROL CORD TO THE BLAST HOSE WHERE THE LOOP ENDS BY WRAPPING THE TAPE AROUND THE TWINLINE/CONTROL CORD TWICE AND THEN AROUND THE BLAST HOSE.  THIS CREATES A STRAIN-RELIEF ATTACHMENT AND IS ONLY NECESSARY ON THE FIRST CONNECTION NEAR THE CONTROL HANDLE.  STARTING FROM THE NOZZLE END OF THE BLAST HOSE, ATTACH THE TWINLINE/CONTROL CORD TO THE BLAST HOSE BY WRAPPING DUCT TAPE AROUND BOTH EVERY 3 FEET.