ELECTRIC SEALED REMOTE CONTROL SWITCH W/ BALL CHAIN, 2 PRONG MALE CONNECTOR (DEADMAN CONTROL HANDLE)

ELECTRIC SEALED REMOTE CONTROL SWITCH W/ BALL & CHAIN, 2 PRONG MALE CONNECTOR (DEADMAN CONTROL HANDLE)

This product is compatible with the following OEM manufacturers

IDS Blast is an authorized distributor of Pirate Brand®, RPB Safety®, Bullard®, Blast-It-All®, Trinco™ & Graco®.
We are not an authorized distributor of the other manufacturers listed above.

NOT FOR USE WITH STEEL ABRASIVES (SEE HANDLE WITHOUT PLUG AND SEALED CONNECTOR PB-31131 FOR USE WITH STEEL ABRASIVES)

THIS PRODUCT FEATURES A BALL AND CHAIN DESIGN SO THAT IF THE OPERATOR DROPS THE BLAST HOSE, THE BALL THAT IS CHAINED TO THEIR WRIST DISENGAGES THE CONTROL HANDLE

WARNING!  WHEN USING THIS CONTROL HANDLE, THE CHAIN MUST BE SECURED AROUND THE OPERATORS WRIST.  IT IS UNSAFE TO USE THIS CONTROL HANDLE WITHOUT THE BALL & CHAIN

PROPER REMOTE CONTROL ATTACHMENT INSTRUCTIONS
ATTACH THE REMOTE CONTROL HANDLE TO THE BLAST HOSE NEAR THE NOZZLE WITH HOSE CLAMPS OR HEAVY WIRE TIES.  FORM A LOOP OF TWINLINE/CONTROL CORD THAT COMES 6" AWAY FROM THE BLAST HOSE, RUNS 6" PARALLEL TO THE BLAST HOSE, AND COMES 6" BACK TO THE BLAST HOSE.  USING DUCT TAPE, ATTACH THE TWINLINE/CONTROL CORD TO THE BLAST HOSE WHERE THE LOOP ENDS BY WRAPPING THE TAPE AROUND THE TWINLINE/CONTROL CORD TWICE AND THEN AROUND THE BLAST HOSE.  THIS CREATES A STRAIN-RELIEF ATTACHMENT AND IS ONLY NECESSARY ON THE FIRST CONNECTION NEAR THE CONTROL HANDLE.  STARTING FROM THE NOZZLE END OF THE BLAST HOSE, ATTACH THE TWINLINE/CONTROL CORD TO THE BLAST HOSE BY WRAPPING DUCT TAPE AROUND BOTH EVERY 3 FEET.