EXTERNAL RELAY ASSEMBLY

EXTERNAL RELAY ASSEMBLY, ALLOWS THE TRIGGERING OF EXTERNAL DEVICES WHEN THE CO MONITOR EXPERIENCES AN ALARM CONDITION

When the Monitor experiences an alarm condition, a power signal is provided at the external alarm jack where the External Relay Assembly’s signal cable is plugged into. This power signal energizes the External Relay Assembly and turns the external device ‘ON’ or ‘OFF’, depending on how the power source is connected to the External Relay Assembly’s terminal block. NOTE: The Monitor must be powered by the Optional 120 VAC Adapter (80247) or 12 VDC Adapter (80123) to energize the External Relay Assembly.

WARNING: THIS DEVICE SHOULD ONLY BE INSTALLED BY A QUALIFIED ELECTRICIAN. OBSERVE ALL STATE AND LOCAL ELECTRICAL CODES WHEN INSTALLING THIS DEVICE TO ASSURE SAFE INSTALLATION AND OPERATION. FAILURE TO PROPERLY INSTALL THIS DEVICE COULD RESULT IN PERSONAL INJURY, DEATH, PROPERTY DAMAGE OR DAMAGE TO THE EQUIPMENT.

WHEN USING WITH RPB® GX4 GAS MONITORS, A 08-434 AUX CABLE IS REQUIRED.